For more information see Custom overlays for BCR

For more information see Custom overlays for BCR
Do you also have the problem that sometimes the an oscillator of your Behringer Neutron is out of tune when you bypass its tune pot?
I had that a couple of times now and didn“t know what to do about it until today.
I assumed being driven by 3340 ICs the Neutron would not need any warm up time but maybe I am wrong. However during boot the Neutron calibrates the OSCs internally. I found that when you lock a Tune pot and the corresponding oscillator is out of tune thereafter, you should switch power off and back on so to force re-calibration. Mine was perfectly in tune after having done so.
Following a topic on a forum I modded my VP1 for slower sweeps of over one minute. Continue reading
If all of a sudden you are getting an error message on your Computer stating that your USB device failed then this is most likely due to worn out capacitors of the power supply.
I successfully got my device working again by replacing the two 1000uF electrolytics. The original ones where causing ripples on the supply voltage which lead to instable USB signals.
Synth In A Case is an ensemble for Native Instruments Reaktor.
You will have to manually assign the controllers used by the BCR preset.
BCR2000_Reaktor_SynthInACase.zip